Preconditions for installation
Room
Equipment is designed for use in indoor conditions. The temperature of the room where the equipment is used should be between 5°C-40°C and the relative humidity of the room should not exceed 85 %. As in the working regime the machine creates humidity, be sure that the construction of the room is moisture proof and the room has ventilation. It is recommended to have a general trap on the floor. It is important that after installation there will be adequate room for the cover of the equipment to be easily opened as there must be sufficient room during the service maintenance.
Power
The electrical installation of the Harmony equipment should be carried out by qualified specialists. Power cord should be protected with the protective switch which is in accordance with requirements (CEI 64-8). Power cord material should be at least 3x2,5 mm² copper crosscut wire. The Power cord should be connected without intermediate connections to the moisture proof junction box on the wall close to the equipment. Maximum combined power consumption for the equipment is 4,5 kW. The protective device current in front of equipment feeder is 20 A.
Water
Clean water is important for the normal functioning of the equipment. If the rust and mineral matter consistency in the water is too high, then it is advisable to install water filters. The recommended water pressure is 2-4 Bars. 2 water pressure hoses are required, one for hot another for cold water with the ending being ¾" threaded.Water drainage hose should be of 50 mm. The length of drainage hose depends on the distance from drainage opening on the ground.
Contact with one of our Salon Design Specialist Today to add the Harmony Dream to your Salon Equipment.
Call 800-762-1017
|
